USB INSTALLATION AND RECOVERY

Flash an OFE device

Select the exact hardware target, connect it by USB and install the complete merged firmware image.

STEP 1

Select the device

Loading firmware catalog

Hardware target

Version: -
Processor: -
Flash: -
Signature target: -

Confirm the target before continuing. The web flasher writes the complete image at address 0x0. Erase the device for a first installation, a firmware-family change or a partition-layout change.

STEP 2

Connect and install

Disconnect the OFE bus and attached equipment before connecting USB.

Web Serial is not available. Open this page in a current desktop version of Chrome or Edge.

The flasher requires HTTPS or localhost access.

Manual files Download merged image Download signed OTA package

BEFORE POWER-UP

Commissioning checks

Verify the selected module family and display resolution.
Use a stable USB cable and keep the OFE RS485 bus disconnected while flashing.
After installation, open the serial console at 115200 baud and confirm a clean boot.
Reconnect the bus only after the target starts with the expected firmware name and version.

Merged image SHA-256: -